nanoKONTROL2 Operation Mode

[Tall Skeptic]

Hi everyone. First post, and I have a question:

I am missing something basic with the nanoKONTROL2. How does one switch the operation mode from DAW to CC mode? The manual states "To engage the desired mode, turn on the unit while pressing and holding down the button that corresponds to that mode." As far as I know, there is no DAW mode or CC mode button. What am I missing?

Thanks,
Steve

[spitfire31]

Hi everyone. First post, and I have a question:

I am missing something basic with the nanoKONTROL2. How does one switch the operation mode from DAW to CC mode? The manual states "To engage the desired mode, turn on the unit while pressing and holding down the button that corresponds to that mode." As far as I know, there is no DAW mode or CC mode button. What am I missing?

Thanks,
Steve

Your missing 'RTFM'!

There are two ways.

1) Locate the key combination to press while powering up NK2. For instance, to activate the DP DAW mode, you hold down the FF and SET MARKER buttons while powering up. It's all listed in the manual.

2) In Korg Kontrol Editor, clilck on the square with the three hyphens superimposed on the LED position in the illustration on top (top left corner). Then you get a menu in the lower half of the Editor, with a Control Mode drop-down.

Did I mention that this is all in the fine manual?