Loading samples from SmartMedia card onto Triton LE

Discussion relating to the Korg Triton LE and Korg TR

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
Artmuzz
Junior Member
Posts: 84
Joined: Wed Nov 24, 2010 2:54 pm

Loading samples from SmartMedia card onto Triton LE

Post by Artmuzz »

I recently bought a Korg Triton LE and I remember reading somewhere that it is possible to put own made samples or other samples from internet onto SmartMedia card then play the samples back on Korg Triton LE from SmartMedia card even though there is no Sampling board installed. Is this true? Also, can the Triton LE read wav files?
User avatar
SeedyLee
Platinum Member
Posts: 1397
Joined: Wed Sep 13, 2006 1:48 pm
Location: Perth, Australia

Re: Loading samples from SmartMedia card onto Triton LE

Post by SeedyLee »

Artmuzz wrote:I recently bought a Korg Triton LE and I remember reading somewhere that it is possible to put own made samples or other samples from internet onto SmartMedia card then play the samples back on Korg Triton LE from SmartMedia card even though there is no Sampling board installed. Is this true? Also, can the Triton LE read wav files?
Yes, this is true, but you will need to install Sample Ram to load the samples into. Also, you will not be able to edit them at all. But for loading premade samples, it works fine. You can install up to 64MB of RAM, just make sure you read the Triton's documentation to make sure you get the right type.
Current Equipment:
Korg Kronos 2 88, Reface CS, Roland JV-1080, TE OP1, Moog Subsequent 37, Korg ARP Odyssey, Allen & Heath Zed 18, Adam F5, MOTU MIDI Express XT, Lexicon MX200 & MPX1, Yamaha QY700, Yamaha AW16G, Tascam DP008ex, Zoom H6, Organelle, Roland J6 & JU06A

Previous: Triton LE 61/Sampling/64MB/4GB SCSI, MS2000BR, Kronos 1 61, Monotribe, NanoKontrol, NanoKeys, Kaossilator II, Casio HT3000, Roland VP-03, Reface DX, Novation Mininova, MPC One
User avatar
The Great One
Posts: 6
Joined: Fri Jul 13, 2012 10:39 am
Location: India
Contact:

Re: Loading samples from SmartMedia card onto Triton LE

Post by The Great One »

Artmuzz wrote:I recently bought a Korg Triton LE and I remember reading somewhere that it is possible to put own made samples or other samples from internet onto SmartMedia card then play the samples back on Korg Triton LE from SmartMedia card even though there is no Sampling board installed. Is this true? Also, can the Triton LE read wav files?
I don't know about the LE, but I tried this with my TR. Without the sampling board installed you can only load and save .pcg files (via the memory card) and also they can be edited later on. But to load and save .pcm the sampling board is required.

All the PCG files format are compatible and interchangeable with the Triton series.
Love and Peace !

Korg TR, Roland XP 60.
User avatar
SeedyLee
Platinum Member
Posts: 1397
Joined: Wed Sep 13, 2006 1:48 pm
Location: Perth, Australia

Re: Loading samples from SmartMedia card onto Triton LE

Post by SeedyLee »

Hi The Great One,

I'm assuming the TR and LE are the same in this respect, but admit I only have direct experience with the LE.

It absolutely is possible to load PCM Sample Data on the LE without the sampling expansion installed, but there are a number of limitations as I mentioned:

1) You must install at least some compatible SDRAM to load the samples into.
2) It is not possible to manipulate the samples in any way. Any loaded samples must be in native Korg KSF/KMP/KSC format - it is not possible to load WAV or AKAI samples without the sampling board.

As Wikipedia says:
At a much lower price than the original Tritons, the Le was nevertheless a commercial success. The on-board sample RAM can load samples from the Smartmedia slot, without the sampling board fitted.
I have done this before I got the EXB-SMPL, but to be honest, it was pretty limiting. Having the EXB-SMPL makes life much easier. Although for a few commercial or must-have sample libraries, it is quite practical to forgo the EXB-SMPL.

Once again, not 100% sure if this applies to the TR, but would be surprised if it didn't.

Hope that helps :)[/list]
Current Equipment:
Korg Kronos 2 88, Reface CS, Roland JV-1080, TE OP1, Moog Subsequent 37, Korg ARP Odyssey, Allen & Heath Zed 18, Adam F5, MOTU MIDI Express XT, Lexicon MX200 & MPX1, Yamaha QY700, Yamaha AW16G, Tascam DP008ex, Zoom H6, Organelle, Roland J6 & JU06A

Previous: Triton LE 61/Sampling/64MB/4GB SCSI, MS2000BR, Kronos 1 61, Monotribe, NanoKontrol, NanoKeys, Kaossilator II, Casio HT3000, Roland VP-03, Reface DX, Novation Mininova, MPC One
User avatar
The Great One
Posts: 6
Joined: Fri Jul 13, 2012 10:39 am
Location: India
Contact:

Re: Loading samples from SmartMedia card onto Triton LE

Post by The Great One »

SeedyLee wrote:Hi The Great One,

I'm assuming the TR and LE are the same in this respect, but admit I only have direct experience with the LE.

It absolutely is possible to load PCM Sample Data on the LE without the sampling expansion installed, but there are a number of limitations as I mentioned:

1) You must install at least some compatible SDRAM to load the samples into.
2) It is not possible to manipulate the samples in any way. Any loaded samples must be in native Korg KSF/KMP/KSC format - it is not possible to load WAV or AKAI samples without the sampling board.

As Wikipedia says:
At a much lower price than the original Tritons, the Le was nevertheless a commercial success. The on-board sample RAM can load samples from the Smartmedia slot, without the sampling board fitted.
I have done this before I got the EXB-SMPL, but to be honest, it was pretty limiting. Having the EXB-SMPL makes life much easier. Although for a few commercial or must-have sample libraries, it is quite practical to forgo the EXB-SMPL.

Once again, not 100% sure if this applies to the TR, but would be surprised if it didn't.

Hope that helps :)[/list]
I am actually thinking of upgrading my TR with the Sampling board. Will research here on the forum about the power. Am pretty new with the TR infact this is my first Korg. The more I spend time with it the more I am loving it. Thanks for the info sir !
Love and Peace !

Korg TR, Roland XP 60.
doctari
Posts: 2
Joined: Sun Jun 16, 2013 1:31 pm

Post by doctari »

New here, thinking of buying a tr61 off my local craigslist, but the seller says the board does not have the sampling upgrade.

So, provided I instal some RAM and I am able to convert/load my samples to the SD card as Korg's KSF/KMP/KSC format, will I be able to apply the filter or adsr to the samples and save them?
stephenuk
Full Member
Posts: 111
Joined: Sat May 25, 2013 12:04 pm
Location: Manchester UK
Contact:

Post by stephenuk »

doctari wrote:New here, thinking of buying a tr61 off my local craigslist, but the seller says the board does not have the sampling upgrade.

So, provided I instal some RAM and I am able to convert/load my samples to the SD card as Korg's KSF/KMP/KSC format, will I be able to apply the filter or adsr to the samples and save them?
i have the sampling option and ram installed but when loading a native wav it says somat about can use wildcard ?* etc then says file unavailable why is it doing this?
Korg Kronos, Korg M3, Korg M1, Korg Triton LE, Kurzweil K2000 V3, Roland MC303, Roland JX305, Roland W30, Casio HT6000, Casio SK200, Akai MPK49
Post Reply

Return to “Korg Triton LE / Korg TR”