Kronos editor

Jordan · Post by **Jordan** » Mon Jul 30, 2012 3:33 pm

Hi, I'm considering to get Kronos so I downloaded Kronos Editor to see the differencies to my M3. I have opened Factory set and evertning looks fine. However when I open a new empty combi and select a Karma modules all GE RTP settings for all modules are empty.

Why is that? Missing something?

pedro5 · Post by **pedro5** » Mon Jul 30, 2012 5:43 pm

I think you need to connect to a Kronos first and they will transfer to the editor,either automatically or by selection.
I may be wrong with this,but had a quick look at my own set up and found they are there.
Not sure if it did so at first connection or they appeared after a total save...??....

Don't forget the Kronos editor is only for the Kronos,so a direct comparison to the M3 may not be accurate.

Jordan · Post by **Jordan** » Mon Jul 30, 2012 7:11 pm

Thanks. I wanted to see if RTP settings for GEs with the same name are the same on Kronos.

I don't have Kronos connected but it is strange that everything is loaded except GE RTP settings on Karma page. Any other ideas?

QuiRobinez · Post by **QuiRobinez** » Mon Jul 30, 2012 7:13 pm

Jordan wrote:Thanks. I wanted to see if RTP settings for GEs with the same name are the same on Kronos.

I don't have Kronos connected but it is strange that everything is loaded except GE RTP settings on Karma page. Any other ideas?

The rpt settings are the same, the karma engine is the same as in the M3

Jordan · Post by **Jordan** » Mon Jul 30, 2012 7:49 pm

Thanks, this is what I wanted to know. Do you know if there is a way to show RTP settings on Kronos editor without connecting Kronos?

QuiRobinez · Post by **QuiRobinez** » Tue Jul 31, 2012 5:55 am

Jordan wrote:Thanks, this is what I wanted to know. Do you know if there is a way to show RTP settings on Kronos editor without connecting Kronos?

No idea, i don't use the editor of the kronos.

When i transfered m3 combis to the kronos i did this by opening the combi in the m3 editor and then select each program and setting by hand in the kronos.

This works but is very time consuming. Things to keep in mind during that proces is that not every m3 program is available in the kronos and the KARMA ge has to be found by name, because they are in a different order then on the m3.

Jordan · Post by **Jordan** » Tue Jul 31, 2012 6:47 am

Thanks a lot.

Do you know if at least RTP settings are in the same order in particular Karma GE as on M3?