bypassing insert effects

[Teemeister]

Hello All...

I've downloaded several MOSS sounds (made for the Z1 but compatible with Trinity's MOSS board) from korgforums and I'd like to use the Master Effects only.

Is there a way to disable Trinity's insert effects without also turning off the whole Master Effect section? I've tried playing with send levels on P7 but that's not working. As soon as all three insert effect slots are OFF, the Master effects are gone too.

[Timo]

Hi.

http://www.korgforums.com/forum/phpBB2/ ... 921#298921

Trinity Parameter Guide, page 48.

Or press P7 on the Trinity and for each insert effect displayed either select OFF, or change Size to equal '0'.

[Teemeister]

Hi.

http://www.korgforums.com/forum/phpBB2/ ... 921#298921

Trinity Parameter Guide, page 48.

Or press P7 on the Trinity and for each insert effect displayed either select OFF, or change Size to equal '0'.

OK I figured it out. Setting all of them to (size) 0 will also turn OFF the whole Master Effects section. The trick is to set at least one insert effect to size 1 (or higher) but turn OFF the actual effect. A bit un-intuitive but it works and hopefully doesn't steal processing power.

[Timo]

My bad.

Ignore Insert Effects page (P7) totally. Set everything to Size 0 and Off.

Instead go to the Amp screen, and the two Send values along the bottom can be tweaked, and these will go straight to the Master effects.

No need to allocate sizes to inserts.

[Teemeister]

My bad.

Ignore Insert Effects page (P7) totally. Set everything to Size 0 and Off.

Instead go to the Amp screen, and the two Send values along the bottom can be tweaked, and these will go straight to the Master effects.

No need to allocate sizes to inserts.

Yep, this is how it's supposed to be done! These sends are zero'd by default.

Thanks!