question on RPPR...

miden · Post by **miden** » Thu Feb 14, 2013 1:41 am

How many bars can a single user midi pattern be to import into RPPR mode?

In other words is there a limit to the # of bars...could one use a pattern of say 16 bars in length?

miden · Post by **miden** » Thu Feb 14, 2013 5:09 pm

Anyone????

MarPabl · Post by **MarPabl** » Thu Feb 14, 2013 6:52 pm

AFAIK there are no limits... but try that anyway.

miden · Post by **miden** » Thu Feb 14, 2013 6:55 pm

Thanks Marparbl - I couldn't find an exact note of this in any of the manuals..So yeah, suck it and see hey

Cheers

dfahrner · Post by **dfahrner** » Thu Feb 14, 2013 7:48 pm

99, I think...

miden · Post by **miden** » Thu Feb 14, 2013 7:56 pm

thanks DF...I thought that (99) was related to how MANY user patterns per song, not how long each one can be...

That was how I read that section, but of course, I may have misunderstood...

dfahrner · Post by **dfahrner** » Thu Feb 14, 2013 8:59 pm

In SEQUENCER P5:Pattern/RPPR, under Pattern Parameter, you can set the pattern length to 01 - 99 (ya got two decimal digits)...

miden · Post by **miden** » Thu Feb 14, 2013 10:27 pm

ahhh okay - yeah I have not yet played with the "hardware buttons" on this issue yet, I have only read the section in the manual...

Thanks m8

D

miden · Post by **miden** » Thu Feb 14, 2013 10:33 pm

I am looking at that page and I can not see any box for Pattern Parameter??

Can you advise where it can be found?

EDIT:

It's okay it is under the drop down menu, top tight...

keekma · Post by **keekma** » Sat Feb 16, 2013 7:53 pm

miden wrote:I am looking at that page and I can not see any box for Pattern Parameter??

Can you advise where it can be found?

EDIT:

It's okay it is under the drop down menu, top tight...

I did try this parameter. Set it to 5. Then I tried to copy more than one measures from a miditrack. But with the copy function you only can copy one measure. Is it possible to copy more than one measure?