combining timbres

Mike H · Post by **Mike H** » Sun Apr 06, 2008 5:26 pm

trying to make new COMBI combinaton but cannot get second timbre to sound. Have been following manual instructions but no success. Any advice?

Bazz02 · Post by **Bazz02** » Mon Apr 07, 2008 9:34 am

Use a default combi that is sounding on 2 timbres
and just change to your liking.

Timo · Post by **Timo** » Mon Apr 07, 2008 10:32 am

Hiya, press COMBI, then EDIT, then P1.

Make sure the 2nd timbre is set to the same MIDI channel as chosen for the 1st timbre (as shown at the bottom).

Do this for the 3rd, 4th, 5th timbre etc. if you want to add these to the combi, too.

maxibrady1 · Post by **maxibrady1** » Fri May 17, 2013 12:41 pm

I cant get them to work either they are all on same midi channell
I can get 1 to 3 working but the rest of timbres no sound.
Amy advice would really appreciate it. ..max.
Korg trinity.

Timo · Post by **Timo** » Fri May 17, 2013 3:33 pm

maxibrady1 wrote:I cant get them to work either they are all on same midi channell
I can get 1 to 3 working but the rest of timbres no sound.
Amy advice would really appreciate it. ..max.
Korg trinity.

Make sure the timbres are being routed to the correct output jacks (1 & 2), and/or that they are not muted elsewhere.