How to Open an .SNG after a Load

ashleylm · Post by **ashleylm** » Sun Aug 18, 2013 10:12 pm

Hi!

Still hoping to master the basics. I've created an .SNG / PGC, saved it on my SD card, and then pressed LOAD, and all seemed well, but where did it load to? How do I get at it?

After the load, the "OPEN" button became available, but if I press it nothing actually opens. it takes me "inside" the song folder. I'm opening the folder, not the song.

I just want to be able to create midi files on my PC, and play them in Krome after assigning Krome's wonderful sounding programs to each channel. I suspect I've mastered the assigning programs and creating songs, but not the finding-the-song-again-after-loading it, and that's the problem--it's no good to me having a bunch of songs on an SD card if I can't play them.

So after LOAD, what do I do?

Sorry to be so obtuse,

Ash

X-Trade · Post by **X-Trade** » Mon Aug 19, 2013 12:29 am

Press the SEQ button, to go into sequencer mode... When you load songs they go in there.

ashleylm · Post by **ashleylm** » Mon Aug 19, 2013 2:57 am

Thanks for the reply--turns out I'm even dumber than I thought ... the songs WERE showing up when I pressed SEQ, but I couldn't hear them as local control midi in global settings was turned off.

Thanks!