Korg T1 lost B bank sounds

Discussion relating to all other KORG synth related products that don’t have a dedicated section. For example, OASYS PCI, M1, N Series, 01W series, T series, and more…

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
User avatar
kellykeys
Posts: 11
Joined: Thu Apr 25, 2013 2:06 am
Location: Spokane, WA.

Korg T1 lost B bank sounds

Post by kellykeys »

After replacing all the tactical switches, my programs B bank are all messed up.. A bank is just fine....tried to reload and come up with the results. Any odeas on what to try next... I also noticed that in my disk screen, it does not show to load PCM sounds anymore.... Love the board and want to get it fixed....
Kellykeys
Vins
Posts: 4
Joined: Sat Nov 08, 2014 2:00 pm

Post by Vins »

Seems to me that you've disconnected part of the EX memory module or the whole flat cable that connects the memory card to the motherboard...
double check if the KLM-1385 card is firmly connected and the flat white cable near the battery:

Image[/img]
Korg did it better :)
T3owner
Senior Member
Posts: 369
Joined: Fri Jun 17, 2011 5:40 pm
Location: USA

Post by T3owner »

Previously addressed and resolved. See:
http://www.korgforums.com/forum/phpBB2/ ... hp?t=92640
Vins
Posts: 4
Joined: Sat Nov 08, 2014 2:00 pm

Post by Vins »

Oops... :roll:

Not bad as a new user and for the very first post...

But at the end at least it seems I was right suspecting about the cables :P
Korg did it better :)
T3owner
Senior Member
Posts: 369
Joined: Fri Jun 17, 2011 5:40 pm
Location: USA

Post by T3owner »

Vins wrote:Oops... :roll:

Not bad as a new user and for the very first post...
It certainly wasn't obvious that the problem had been resolved. I only posted the link to the other thread so that anyone reading this thread would know.

 
Vins wrote:But at the end at least it seems I was right suspecting about the cables :P
Yes, good diagnosis on your part. =D>
Post Reply

Return to “Korg Synths (General)”