I have connected both outputs to my audio interface but I can not figure out how to adjust the L/R "BALANCE" in the Mixer to send to one or the other.
Is this possible?
Isolating L/R outputs
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Not sure if this is your issue, but keep in mind that even if you pan a sound fully to either output, if that sound is routed though effects, the wet portion (and possibly some dry depending on the effects settings) will still be sent to the other output. To completely isolate sounds to left/right outputs, you either have to run them dry or make adjustments in the effect(s) being used.