Editing Dynamics in Sequencing

Tikiman · Post by **Tikiman** » Wed Feb 25, 2015 4:12 pm

I'm doing a show and I'm sequencing the instruments that I don't have in the pit (Trombone 2, Trumpet 3, Reed 3 and 4 etc).

My question is: How do I alter the volume of just certain notes in a track? I know I can lower the entire track with the mixer, and I can play things in with a certain degree of touch sensitivity. AND I can also give myself volume changes with the volume pedal in performance...

BUT I'm trying to create a brass Sfz while the other instruments are just holding... I'm sure there must be a way to do this, but I can't seem to find it.

Thanks!

dimitra · Post by **dimitra** » Wed Mar 11, 2015 12:35 pm

Not sure if this would help you, but... I do remember in the track-edit page in sequence mode, there is an option to edit the velocity range of the notes over selected measures. Maybe you can play around with that to get your intended volume change?

Ajbbklyn · Post by **Ajbbklyn** » Thu Mar 12, 2015 1:05 pm

I don't have the M50 (or the manual or parameter guide) in front of me. So, this is more of a conceptual answer.

If you can apply MIDI filters on a per track basis, then you could operate the volume pedal for the brass sforzando. The other tracks would be set up so that the cc message for volume change is filtered out. Only the track(s) containing the brass would be affected.

Again, I don't have the reference manuals in front of me but this would seem to be the way to accomplish the desired result.