Using more than 1 Audio In OSC at a time?

Tarekith · Post by **Tarekith** » Sun May 03, 2015 3:47 pm

I could have sworn I had this working before for layering different effects on the input signal with mulitple parts, but for some reason I can only get one Audio In OSC to work at a time today.

Trigger steps are set correctly, everything is unmuted, volumes for each part are up, etc. Anyone else had this issue?

roblabs · Post by **roblabs** » Sun May 03, 2015 6:28 pm

Are you remembering to raise the osc edit knob for each audio in part?

Tarekith · Post by **Tarekith** » Sun May 03, 2015 6:34 pm

Edit:

Yep, that was it! Thanks for the reminder, I knew it was something simple I was forgetting.

captain johnson · Post by **captain johnson** » Sun May 03, 2015 6:48 pm

I have a kind of related question on the audio thru......

If I use 2 volcas have synced to E2 an want to put both volcas into the audio thru via a belkin rockstar.....will it work??

Tarekith · Post by **Tarekith** » Sun May 03, 2015 6:51 pm

Looks like it should, even though you're using it in the reverse of how it's intended.

captain johnson · Post by **captain johnson** » Sun May 03, 2015 6:56 pm

Tarekith wrote:Looks like it should, even though you're using it in the reverse of how it's intended.

Elaborate.....

atb1983 · Post by **atb1983** » Mon May 04, 2015 11:54 am

I think Tarekith might just be saying that the Rockstar is intended to split an output rather than mix inputs, but yeah - people use them as passive mixers for the Volcas pretty often now, I think.

Hugo · Post by **Hugo** » Mon May 04, 2015 1:27 pm

Interesting about the Belkin Rockstar. What is the quality of this thing? It's so cheap, it would be great to use this as a small "mixer" for several small synths and recording them into a sampler. But how good is the sound quality?