Control Polysix via nanokontrol 2

john.jackson1982 · Post by **john.jackson1982** » Tue Jun 09, 2015 6:20 pm

Hi,

is there a way to to control the Polysix in the Kronos with my nanokontrol 2? I already assigned for example CC 74 to the nanokontrol 2 which is suppose to control the Filter Cutoff of the Polysix, but it doesnt work. Any ideas?

Thank you very much

ronnfigg · Post by **ronnfigg** » Thu Jun 11, 2015 8:25 am

Did you set up the nanokontrol2 for CC Operating Mode?

john.jackson1982 · Post by **john.jackson1982** » Thu Jun 11, 2015 8:27 am

Hi, thanks for your answer. Can you tell me how to set the nanokontrol 2 to CC Operating mode? That would be great.

Thanks in advance

john.jackson1982 · Post by **john.jackson1982** » Thu Jun 11, 2015 12:13 pm

Hi,

thanks for your help. It took me a while, but I think I found it:

For the NK2 CC mode, hold down set marker and cycle then connect the usb cable.

all the best