ESX-1 won't sit flat

reedster · Post by **reedster** » Fri Jul 10, 2015 4:28 pm

I just received an ESX-1 in the mail and it doesn't quite sit flat on my desk. Rather the bottom left corner is lifted up about a half inch. Anyone know of an easy fix/solution to this?

tim from texas · Post by **tim from texas** » Fri Jul 10, 2015 8:35 pm

mine did this too.. i used two pennies stacked on top of each other.

#gamechanger

Hugo · Post by **Hugo** » Sat Jul 11, 2015 9:37 am

Mine as well. Just put some folded paper under the relevant pad.

dutchcow · Post by **dutchcow** » Sat Jul 11, 2015 10:02 am

Two pretty easy fixes. A less easy fix would be to make your own case from plywood or print one on one of these fancy 3d printers.

reedster · Post by **reedster** » Sat Jul 11, 2015 4:39 pm

Good to know I'm not the only one. Thanks all.

blackmental · Post by **blackmental** » Mon Jul 13, 2015 2:35 am

I have bought two units as well, brand new, and none of them sit flat.