MS20ic Start up settings

palindrome · Post by **palindrome** » Sat Sep 12, 2015 12:02 am

Hi,

Does anyone know how you can initially start the controller and VST up so the software reads the controller parameter settings?

At the moment the VST starts in a pre-programmed patch state and not how the controller is set up??

westikle · Post by **westikle** » Fri Oct 02, 2015 8:33 am

I second this motion. Would love to know this.

westikle · Post by **westikle** » Wed Oct 07, 2015 10:44 am

Ok this is what I've noticed. If you have the controller turned off (via volume knob) it still works as a controller. When you turn the knob on, the vst instantly sets all parameters to match the controller. You can then turn it off again.