Set CC value for Program or Timbre

[nastri83]

Hi All,

Hopefully an easy question:

Anyone know how I can lock the sustain/damper pedal to the on position in a program or timbre (or both)? I know that it would be midi CC 64. I just want to know how to set that to 127 for a specific program or timbre.

Thanks!

[Bald Eagle]

The Hold parameter might accomplish what you want. From page 39 in the Parameter Guide...

Hold is like permanently pressing down on the sustain pedal. In other words, notes continue to sound as if you were holding down the key - even after you lift your fingers from the keyboard.

Unless the Sustain Level is set to 0 in Amp EG 1 (and Amp EG 2 in a Double Program), the sound will play for the entire length of the sample(s).

On (checked): The Hold function is enabled for the range set by the Hold Bottom and Hold Top parameters, below.

Off (unchecked): Notes will play normally. This is the default setting.

[nastri83]

Thank you sir!

[geoelectro]

You can also stop a held note by pressing the compare button.

Geo