DISPLAY: normal mode is blurry, and setup mode is sharp

Bescki · Post by **Bescki** » Sun Aug 20, 2017 3:50 pm

Something that I don't like is blurry display. I think the software is not designed for this display resolution. The resolution is for Pa 1,2, 3 screens.

I was waiting that they will redesign the interface, but programmers didn't.

The only thing that programmers did for screen on Pa4x is the setup screen, so in update screen you can see the better resolution.

Am I wrong?

Ron · Post by **Ron** » Mon Aug 21, 2017 11:44 am

Many forum members, including myself, have expressed disappointment with the display. Hopefully it will be improved in the future.

Vex · Post by **Vex** » Thu Aug 24, 2017 7:50 am

Yes,I Agree. This was discussed from the start,but so far nothing is done about it.

pawlikp100 · Post by **pawlikp100** » Thu Aug 24, 2017 9:25 am

Vex wrote:Yes,I Agree. This was discussed from the start,but so far nothing is done about it.

I don't agree. In my opinion displayed data in OS v2.0.x is sharper.

Vex · Post by **Vex** » Thu Aug 24, 2017 9:30 am

Yes, there is a little improvement in font sharpening, but resolution is the same.

Asena · Post by **Asena** » Sun Aug 27, 2017 10:37 pm

Guys Do not wait for any display impros, It,s not coming!

karmathanever · Post by **karmathanever** » Mon Aug 28, 2017 4:16 am

Hi Asena
Haven't heard from you for a while - hope all is good with you.

Asena wrote:Guys Do not wait for any display impros, It,s not coming!

I also think you are most likely correct
I don't have an issue with screen and prefer it to the PA3X and the Kronos.

It's all in the "fingers" of the beholder of course

Cheers

Pete

duby2 · Post by **duby2** » Mon Aug 28, 2017 11:44 am

I think more resolution or a cleaner screen will just slow down the screen , more resolution take up memory and it will get slow.

IMOP