Hi,
I try to start a sound from scratch - is there any way to initialize a single program before editing?
Could not find anything about that in the manuals...
Ser
Korg 01/w single program to init
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Okay, that is the solution I found ... working on 01/wfd ..
1. Reset the synth (Comp+Reset+PowerOn).
2. Write Combi/Progs to Disk
3. Load Factory defaults (Global->Page7->Load)
If you now want any Prog or Combi to be Init - select Prog or Combi.
Load single Prog/Combi from Disk.
Of cause there is the way with a midi editor ... but I did not test it yet.
1. Reset the synth (Comp+Reset+PowerOn).
2. Write Combi/Progs to Disk
3. Load Factory defaults (Global->Page7->Load)
If you now want any Prog or Combi to be Init - select Prog or Combi.
Load single Prog/Combi from Disk.
Of cause there is the way with a midi editor ... but I did not test it yet.