Korg Minilogue XD sequencer sending data to all instruments

Feythur · Post by **Feythur** » Fri May 10, 2019 10:37 pm

Hi,

So my problem is that the midi data from the sequencer (and keys) is sending to all tracks in Logic Pro x.

Basically if I have a sequence playing (korg xd) on a channel in logic (is is set up using external device, correct audio in and say midi channel 1). I then have a track set up for my rev2, same input method but on say midi channel 2...

The problem is that logic records all the sequence data from the korg xd onto the Rev2 track!! Help, not experienced this before.

I think I need to stop the Xd sending midi to other instruments - but I’m stuck. My rev2 isn’t displaying the same problem.

Cheers

Dan

megamarkd · Post by **megamarkd** » Sat May 11, 2019 2:00 am

Check the MIDI channel setting on the XD, make sure you are not in OMNI mode (which will send and receive on all channels).

Feythur · Post by **Feythur** » Sat May 11, 2019 6:11 am

Where in the menu do I find Omni mode?

LM · Post by LM » Sat May 11, 2019 4:02 pm

Omni Mode only applies to the receiving end by definition, as in ignore channel data and accept all incoming commands, regardless of MIDI channel. In this situation, it would mean that the Rev2 is the one that might be set to Omni mode (receiving in all channels), rather than the XD.

Feythur · Post by **Feythur** » Sun May 12, 2019 8:05 am

Many thanks - this has helped me trouble shoot the problem! Just need to figure out how to implement this in logic. I think logic holds my problem. The Rev2 is set up to only receive on channel 1&2.