Bass sound

Stefkorg · Post by **Stefkorg** » Mon Nov 01, 2021 5:36 pm

Hy guys, can someone give me a tip how to make from factory sounds "new init" a bass sound. So i prefer a soft bass sound that comes clearly out, anything that is nearby like a real bass guitar. Which factory bass sound should i use, how to mix filters and which efect should i use? Or have someone a good bass sample? Thank you very much

Dan Stesco · Post by **Dan Stesco** » Mon Nov 01, 2021 7:35 pm

Do you have a link with your preferred bass sound? It's better to understand what you looking for.

Stefkorg · Post by **Stefkorg** » Tue Nov 02, 2021 5:50 am

https://youtu.be/QvNMhxZpBfM

From 45:30 you can hear that bass sound with that string effect

Dan Stesco · Post by **Dan Stesco** » Tue Nov 02, 2021 3:42 pm

What can I distinguish in this poor recording is a Finger Bass. Try to start from Finger Bass 1 from pre-set and edit the Filter EG Velocity to A from 72 to 24. Could be very close to the sounds that you looking for. To have the same layer sounds will have to edit the user scale to obtain the interval between two same program very used in the Balkan area named TERCA. If need more detail please let me know.

Stefkorg · Post by **Stefkorg** » Tue Nov 02, 2021 7:18 pm

I did what you say and i dont know it sound for me too middle. What you meant with user scale? I heard that bass sound when i was on live on a gig some band played and i really was amazed. Can you give me some tip how to mix filter routing low pass, high pass and other, should i use in one osc finger bass and other som other bass and mix them. And what ifx use? I wanna a bass that comes soft out with a string effect. Just want to know if someone have a tip how it can sound better than i will try again. Thank

Quark · Post by **Quark** » Wed Nov 03, 2021 6:44 am

There is an EXs 155 Purgatory Creek Soundware E-Basses

I'm using that on, its a lot better than the internal bass sounds

Stefkorg · Post by **Stefkorg** » Wed Nov 03, 2021 8:52 pm

So i finaly made that sound what i want. I have in osc1 Finger bass 1 and layer with slap bass (velocity) and in osc 2 i have acoustic string noise a for the string effect. But that string noise comes to heavy out. Do i need to do something in filter settings or amp setting so that it comes a little bit lighter out so that all matches together? Thanks

voip · Post by **voip** » Wed Nov 03, 2021 9:51 pm

For the newly created Program, go to the Control Surface tab, and select the Timbre/Track button at the left hand side of the keyboard, or the EXi1/Exi2 tab on the screen. There should be three controls at bottom left of the screen for setting the levels of the two Oscillators and the Drum Track.
.