I notice there’s an unusual way of installing libraries on Triton Studio vs my old Triton Classic. Korg support will only send me links to specific sections of the manual. I have done everything I needed to do to get factory OS, updates, libraries, & expansions installed properly.
Yet MOSS library isn’t sounding when in sequence mode. The names are there, just no sound. If I switch to program mode, they will sound. Almost forgot to mention the MOSS board is installed & plugged in. I was told installing libraries to hard drive will do no good. So I’m assuming this feature was only meant to be a back up utility. Correct me if I’m wrong. But my main focus is why MOSS kit bank F isn’t sounding in sequence mode. I didn’t have this issue when I had Triton pro X 88.
I appreciate any help necessary to get me up & running smooth. It’s just an unusual discouraging situation, hopefully just a minor hiccup I may have overlooked, wishing I stuck with choosing a Triton Classic 61. And Hopefully it’s not the matter of me purchasing a Triton Studio shipped from Japan either.
Triton Studio Moss library not sounding in sequence mode
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
Jaythemenace
- Posts: 2
- Joined: Sat Jun 20, 2020 5:25 pm
Yeah, there's an annoying "Korgism" that requires you to specifically allocate MOSS voices to particular tracks in sequencer mode. In SEQ mode, push the MENU button, select P4:Zone/Ctrl, bottom tab select MOSS 1-8 or MOSS 9-16, change Voice Allocation Reserve from 0 to 1-6.
bpoodoo
Triton Extreme 88 w/MOSS
Triton Extreme 88 w/MOSS
-
Jaythemenace
- Posts: 2
- Joined: Sat Jun 20, 2020 5:25 pm
OH WOW! I had a bad feeling it was a simple fix. I vaguely remember doing this on my old Triton classic. That explains why some of my songs had no more than 2 bank F presets, allocating voices were required.bpoodoo wrote:Yeah, there's an annoying "Korgism" that requires you to specifically allocate MOSS voices to particular tracks in sequencer mode. In SEQ mode, push the MENU button, select P4:Zone/Ctrl, bottom tab select MOSS 1-8 or MOSS 9-16, change Voice Allocation Reserve from 0 to 1-6.
Now I have to figure out how come some factory presets from INT banks C & D are not showing at all.They should be there since expansions load into a separate row of banks. With the Triton classic I had to load specific presets from factory disc to bank E. these presets were naturally replaced with EXB libraries loaded into banks C & D.
Thank you for responding to my question no mater how lame it must have been. there's just curtain steps forgotten with workstations not as important or no longer needed these days.