Sound Levels

For discussion relating to the Korg PA4X arranger

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
User avatar
keithwjones
Full Member
Posts: 149
Joined: Tue Feb 26, 2008 5:15 pm
Location: Somerset, UK (Pa4x-76)

Sound Levels

Post by keithwjones »

Pa4x-76

Every now and then I come across a style where one of the Kbd sets to too loud or soft, compared to the other sets.

If too loud I can lower the volume in Lower or Upper 1 to 3, then save to Songbook.

But what is best way to do it if the sound is too soft.

I have Master Volume and balance plus volume in Lower or Upper 1 to 3.

Max EQ is set up and I know there is a volume control there.

Is there something in Sound Editor that would help?

Keith
Pa4x-76 PaAS Next 3.1.0
Previous Pa800
menara
Posts: 46
Joined: Mon Sep 12, 2016 6:16 pm

Post by menara »

If your sound uses user samples, its better to normalise each sample in order to increase their volume.

Otherwise, you can simply assign, to your sound, an insert effect that increases the volume, like enhancer, compression, amp, etc.

Try this :

Insert Effect = Stereo Exciter/Enhancer

Set Pre LEQ Fc to low-mid
Set Pre HEQ Fc to mid-High
Set Pre LEQ Gain [dB] and Pre HEQ Gain [dB] to +15

This will boost all the frequencies without distorting to much the original sound
Pa4x 76 - Sy77
User avatar
keithwjones
Full Member
Posts: 149
Joined: Tue Feb 26, 2008 5:15 pm
Location: Somerset, UK (Pa4x-76)

Post by keithwjones »

Thanks menara, I will have a look at those settings.

Keith
Pa4x-76 PaAS Next 3.1.0
Previous Pa800
aboncev
Posts: 16
Joined: Sun Feb 25, 2018 1:56 pm

Post by aboncev »

Jesus... This help me so much! Searching on youtube, i didn't found help. But here, that's it! I needed for piano sound. It is so quiet, the factory. And now much reacher, much louder, going on surface. Thank you Menara. You help me a lot.
Post Reply

Return to “Korg Pa4X”