I have been enjoying exploring my Pa5x through lots of playing, sound and Style editing, and recording. Today I decided to finally explore the Matrix instead of just using the Pads programmed into each Style. I immediately ran into a volume issue with the Pads triggered by the Matrix buttons almost blowing out my ears and my speakers until I turned the Master Volume slider all the way down. This was true of all the Matrix pads. I went into the Mixer and set each Matix Pad I was using down to about 20 which aligned with my keyboard and Style volumes when the Master Volume slider was set near the middle. After playing with some of the Pads preset in the Style, and I went back to the Matrix buttons and once again nearly blew out the speakers. The volumes had all been reset from where I had set them in the Mixer.
At this point, it seems like I can't use the Matrix buttons to access Pads without needing to go back each time to turn down the volume of each Pad.
Thanks for any suggestions.
Matrix volume issue.
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
- AntonySharmman
- Approved Merchant
- Posts: 3733
- Joined: Sat Oct 16, 2010 2:24 pm
- Location: Hellas
- Contact:
Music Conductor - Sound Engineer & Developer - Automotive SMPS/RF R&D - Electronics Engineer
Keyboards : Steinway-D, Kronos X, Pa5X 76, Pa4X 76, Montage M7 , Roland-XV88, Emu3,Emax II, Synclavier II , Yamaha DX Series, ΟΒ-8V

wavesΑrt official webpage - KorgPa.gr
DEMO's Playlist - WavesArt Facebook
Keyboards : Steinway-D, Kronos X, Pa5X 76, Pa4X 76, Montage M7 , Roland-XV88, Emu3,Emax II, Synclavier II , Yamaha DX Series, ΟΒ-8V

wavesΑrt official webpage - KorgPa.gr
DEMO's Playlist - WavesArt Facebook