How do I save an organ program with a fast leslie already on? I still want the joystick to turn it on and off, I just want it to start while "ON".
Specifically, I want program G039 to begin with the fast leslie.
Saving fast leslie in a program
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
ultrasteve
- Posts: 33
- Joined: Sat Feb 05, 2011 9:44 pm
- Location: SE Michigan
-
Dan Stesco
- Approved Merchant
- Posts: 677
- Joined: Fri Dec 11, 2009 9:10 am
- Location: Bucharest
- Contact:
Tell me the program you want to change.
Usually the organ CX3 have the rotary in the engine parameter but sometimes the voicing team use IFx also.
To set the CX3 slow to fast by default:
Press Page - select CX3 - Amp/VC/Rotary SP
Select the Rotary Speaker sub Page.
Mod/Speed settings is in the upper right square.
Select the Speed SW from Slow to Fast
Write program
To set the Rotary fast by default in IFX.
Open IFX, Rotary Sp with OD
On the left side will see Speed Switch. Change the Slow to Fast.
Write Program.
Usually the organ CX3 have the rotary in the engine parameter but sometimes the voicing team use IFx also.
To set the CX3 slow to fast by default:
Press Page - select CX3 - Amp/VC/Rotary SP
Select the Rotary Speaker sub Page.
Mod/Speed settings is in the upper right square.
Select the Speed SW from Slow to Fast
Write program
To set the Rotary fast by default in IFX.
Open IFX, Rotary Sp with OD
On the left side will see Speed Switch. Change the Slow to Fast.
Write Program.
-
ultrasteve
- Posts: 33
- Joined: Sat Feb 05, 2011 9:44 pm
- Location: SE Michigan