Setting all style elements volums to be equal

ewart · Post by **ewart** » Thu Oct 08, 2015 2:51 am

Hello All,

I'm sure this topic may have been brought up earlier, I've tried searching but couldn't find any thread.

I have a PA300 & I find that some styles have the intro very loud while the variations are much softer. Is there any way that I can set all the elements to a uniform volume ??? Any help would be great.

I may be asking for too much but is there a way I can have all styles to be of the same volume too ?? I find some styles are very loud while others are soft. Again - any help would be welcome.

Thanks & best regards
Ewart

Daibang · Post by **Daibang** » Thu Feb 25, 2016 5:54 pm

Hello there is a way but it may take some time. You need to do this:
1. Choose that style
2.Go to style edit
3. Choose intro1
4. Choose sound that is too loud.
5.Press menu
6.Press event edit
7.Choose value 2 (It's a volume of one recorded sound)
8.Put your own volume

ewart · Post by **ewart** » Tue May 24, 2016 3:15 am

Thanks Daibang. On further investigation I found that you can copy the characteristics from one part of the style to all the other parts. This works fine for me.

aliersin · Post by **aliersin** » Mon May 30, 2016 10:46 am

Hello @ewart.

Can you describe your procedure ?

Thank you.

Sam CA · Post by **Sam CA** » Tue May 31, 2016 3:34 am

CC#10 (Expression) is your volume controller in Style Record Mode. If you want to balance the loudness of your track in each element, you would have to use CC#10 (Not CC#2).

This is how:

https://www.youtube.com/watch?v=GQ6sughqH4g

angelitto · Post by **angelitto** » Sat Jun 04, 2016 9:57 am

aliersin wrote:Hello @ewart.

Can you describe your procedure ?

Thank you.

In record/edit style/menu/style element track controls. If u like the var1 and the intro1 is to loud, when you are on var1, press top-right and from the drop down menu chouse "copy expression from var1 to intro 1". Then listen intro1 and if its ok, save the style. Good luck!