Korg Forums

Hi, I'm a recent Krome owner, and keyboard come to that, so am definitely a newbie. I seem to have a problem whereby the board intermittantly forgets my user programs between power cycles. It seems as if it remembers them once or twice and then next time, there they are gone!

I don't think I'm doing anything silly, and I'm unclear as to what may be happening short of a fault with the board. The only possible cause I can think of is that I've been messing about with the editor software on the PC, although I can't be sure whether the timings of when it's happened have coincided. I certainly haven't deliberitely deleted, edited or otherwise done something I might expect to be the cause. I don't seem to be having the same problem with combos.

Cheers

Martin

Did you write the changed program(s)? You can check this easily by changing a parameter, go to another program and come back to the first program. If parameters are reverted to their old values, you forgot to write them. Actually, you have to write a changed program before going to another program.

I'm confident I did write them because I tried it through a power cycle after the first time to make sure it wasn't me. At the moment it's so far so good with the test ones I have on there but I haven't connected it to the Krome editor. Perhaps I was doing something silly with that. Will have to try again and see.

Thanks for the reply.

Martin

Check out the setting on the Global System Pref. screen and see if you have the Power-on Mode set to Reset.