Kronos detects wrong keybed size after repair.

Abaek · Post by **Abaek** » Sat Jul 02, 2016 9:16 pm

After having my Kronos 61 (gen. 1) repaired for a dead motherboard. It is now up and running again, but... the system now registers a 73-key keybed instead of the actual 61-key.
How does one correct this? It posses some problems that a key refferenced on screen doesn't match the actual physical key. Any help would be greatly appreciated.
The original D510 motherboard was swapped with a D525, and also prints KLM-3005C and KLM 3006C was swapped with new versions.

Kind regards

danatkorg · Post by **danatkorg** » Sat Jul 02, 2016 9:34 pm

Abaek wrote:After having my Kronos 61 (gen. 1) repaired for a dead motherboard. It is now up and running again, but... the system now registers a 73-key keybed instead of the actual 61-key.
How does one correct this? It posses some problems that a key refferenced on screen doesn't match the actual physical key. Any help would be greatly appreciated.
The original D510 motherboard was swapped with a D525, and also prints KLM-3005C and KLM 3006C was swapped with new versions.

Kind regards

Your national Korg Distributor should be able to help; see the link to contact info in my signature below.

Abaek · Post by **Abaek** » Sat Jul 02, 2016 10:19 pm

Thank you Dan. I'll give it a try.

Korg Forums

Kronos detects wrong keybed size after repair.

Kronos detects wrong keybed size after repair.

Re: Kronos detects wrong keybed size after repair.