SEQ Mode: Non Responsive Track selection

[yoshi88]

My Trinity 88 has just developed an issue.

When in sequence mode, I can not select tracks 2 or beyond!

Using the wheel and buttons will not work.
The touch screen is calibrated and works perfectly.

The track field is the only non responsive software issue on this Trinity 88.

Any thoughts here ?

[Timo]

Hi Yoshi, have you tried a hard factory reset?

If not, firstly make a full backup of your PCG data on your Trinity before doing this, as all data will be lost and you'll need to reload your PCG afterwards to restore your data.

Then turn the Trinity off.

While holding down 'Enter' and '0', turn the Trinity back on again. Hold the keys down for 10-15 seconds or so, until the Trinity is reset.

Then reload your PCG to restore your data.

[yoshi88]

Yes!!!!!

Success... I reinitialized the Trinity PROX and its perfect! The glitch is gone. I replaced the touch screen, 88 note " Yamaha" keybed and floppy drive. ITs as it was 20 years ago. Although it is not a KRONOS I love it all the same. The sounds are just great being unique and vintage... otherwise sounding like everyone else.

Works well with my Triton X and O1W plus Native instrument library.

Thank you!

Hi Yoshi, have you tried a hard factory reset?

If not, firstly make a full backup of your PCG data on your Trinity before doing this, as all data will be lost and you'll need to reload your PCG afterwards to restore your data.

Then turn the Trinity off.

While holding down 'Enter' and '0', turn the Trinity back on again. Hold the keys down for 10-15 seconds or so, until the Trinity is reset.

Then reload your PCG to restore your data.