Assignable sliders..

Bachus · Post by **Bachus** » Wed Jan 18, 2017 5:41 pm

When i touch/move the ballance knob, there is a small window on my touchscreen actually showing how i change it..

Is there an option to set this up so when i touch a slider (assinable a or b) that it shows both the actuall slider vallue as well as the vallue i am changing... including as a reminder what vallue i am changing?

Because it just doesnt work when changing a filter cutoff and you dont see anywhere what the orriginal vallue was....

mstodola · Post by **mstodola** » Wed Jan 18, 2017 6:37 pm

I agree. The Oasys has LEDs that show the initial levels and they don't change until the slider passes the initial value. It seems too many manufactures didn't figure it out, but Korg did. I think something happened. They either got a new team or they've got alzheimers.

Bachus · Post by **Bachus** » Wed Jan 18, 2017 7:44 pm

mstodola wrote:I agree. The Oasys has LEDs that show the initial levels and they don't change until the slider passes the initial value. It seems too many manufactures didn't figure it out, but Korg did. I think something happened. They either got a new team or they've got alzheimers.

Those leds where cut from the Kronos, to save money...

The Oasys and Kronos where developed by Korg Japan, the Pa4x is created by a whole different team in Italy...

Its not an option to have leds on the pa4x.... but if its not possible yet on the pa4x to show the position of the sloders and the value... then it would be a neccesary software update...

Or does noboddy use the assignable sliders?