Factory Pedal Steel Sound

loadsofreverb · Post by **loadsofreverb** » Sun Jan 07, 2018 10:21 pm

Hi, Just recently purchased a PA700 which so far I am impressed with, however the factory installed pedal steel sound is dreadful, sounds like an animal in pain! The pedal steel on my micro arranger and Trinity are beautiful.

Any PA700 owners out there that could confirm what theirs sound like? Its so bad I wonder if I have a corrupted file. Thanks.

Biggles · Post by **Biggles** » Sun Jan 07, 2018 10:35 pm

Any specific one that troubles you or all (there are about 12).

loadsofreverb · Post by **loadsofreverb** » Sun Jan 07, 2018 10:39 pm

The one in Factory Sounds.

loadsofreverb · Post by **loadsofreverb** » Mon Jan 08, 2018 9:03 am

Mode>sound>factory>guitar>tab p4>pedal steel.
I am not sure whether korg have "dropped the ball" on this one or I hsve a faulty unit. Would be very interested what other pa700 owners think. Thanks.

NativeAngels · Post by **NativeAngels** » Mon Jan 08, 2018 10:55 am

I wasn't too impressed by the sound of that guitar either. I did though find editing the Eq settings make the keyboard sound brighter and styles more punchy. Maybe as more of us get the Pa700 we should create some tutorials on getting the best out of the Pa700.

loadsofreverb · Post by **loadsofreverb** » Mon Jan 08, 2018 11:47 am

Thanks for the reply, it sounds so wide of the mark I'm sure something is wrong.

Reuben · Post by **Reuben** » Thu Jan 11, 2018 6:42 am

Here is Pedal Steel you might like to try that I put together this morning.
https://drive.google.com/file/d/1dDJ9Xp ... sp=sharing
It will put two versions to User 1 Sounds slots 9 and 10. (Or if you Open the set, by Load, Open, Sounds, Open, User1, Open....then you can load them where you wish).
It has been built around the Pa3x but assuming similar mapping on the pa700 it should work. It has no new user sound samples but just uses modified versions of factory sounds.

loadsofreverb · Post by **loadsofreverb** » Thu Jan 11, 2018 9:35 pm

Thanks very much. I will give it a go and let you know how i get on.

loadsofreverb · Post by **loadsofreverb** » Sat Jan 13, 2018 8:57 am

Thanks Reuben, big improvement over factory sound.

guitpic · Post by **guitpic** » Wed Jan 17, 2018 7:02 am

loadsofreverb wrote:Hi, Just recently purchased a PA700 which so far I am impressed with, however the factory installed pedal steel sound is dreadful, sounds like an animal in pain! The pedal steel on my micro arranger and Trinity are beautiful.

Any PA700 owners out there that could confirm what theirs sound like? Its so bad I wonder if I have a corrupted file. Thanks.

The Pedal steel sound of my 4X was really bad compared to my Yamaha S970...which is just excellent.

Reuben, if I can figure it out, I’ll try your suggestion for my 4X.

Korg Forums

Factory Pedal Steel Sound

Factory Pedal Steel Sound

Pa700

Re: Factory Pedal Steel Sound