Monologue - LFO Int motion rec

denisp · Post by **denisp** » Tue Mar 06, 2018 11:26 am

Hello,
Did I find a bug ? when I record LFO INT in Motion, the corresponding bar on the LED screen does not vary the same way as any other parameter. It varies only on half of the available height.
I tried many variations, did a factory reset, it's always the LFO INT parameter display that seems buggy.
what do you think ? is there a way to change this or to get a firmware update ?
Thanks

slug · Post by **slug** » Tue Mar 06, 2018 10:54 pm

I think the mistake may be the manual which describes the range as 0 to 1023? LFO depth on Monologue is a bi-polar control (negative range by using shift button) so the range is still full 10-bit, and is displayed as -511 to +511.

denisp · Post by **denisp** » Wed Mar 07, 2018 8:03 am

forgot the shift button... I didn't read the manual carefully enough. Thank you !