I hadn't used my Kronos for a while and went to try to set up a combi to send Karma to multiple external midi devices on different channels. I had everything set up as seemed logical and I could see the karma notes triggering on the combi karma page which shows the notes and channels, but nothing was coming out via midi. In program mode karma is transmitted via midi fine.
Any troubleshooting tips?
Combi Mode Karma
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
CharlesFerraro
- Platinum Member
- Posts: 955
- Joined: Sat Feb 06, 2010 10:15 am
- Location: California
Make sure the track you're sending KARMA to is set to EXT. You can do that on the Play > ProgSelect/Mixer page or the Timbre Parameter > MIDI tab. The option is found under Status on either page.
In regards to your other question about dual mono inputs... Yes it's possible to do in Program mode. Go to the Audio In/Sampling page. You may also go to the Basic > Audio tab in Global mode to set these parameters for every program by default. Note that you can choose to use the Global settings OR save audio-in settings per program by simply checking or unchecking the "Use Global Setting".
Input 1 and 2 are your first two of six possible audio-in channels with the other four being digital inputs via USB or S/P DIF. Things are super straightforward from here. Choose the bus you want to route the signal coming from your audio inputs to. I think you'll have no problem figuring it out. Make sure to pan them both to center (value 64).
In regards to your other question about dual mono inputs... Yes it's possible to do in Program mode. Go to the Audio In/Sampling page. You may also go to the Basic > Audio tab in Global mode to set these parameters for every program by default. Note that you can choose to use the Global settings OR save audio-in settings per program by simply checking or unchecking the "Use Global Setting".
Input 1 and 2 are your first two of six possible audio-in channels with the other four being digital inputs via USB or S/P DIF. Things are super straightforward from here. Choose the bus you want to route the signal coming from your audio inputs to. I think you'll have no problem figuring it out. Make sure to pan them both to center (value 64).
paypal.me/CharlesFerraro