Loading sequence/songs from SD card

joedodd123 · Post by **joedodd123** » Tue Oct 15, 2019 6:46 pm

i followed the manual and im trying to load song i made on the squencer.

i still cant find and load song once iv got the append and clear stage

lidserter · Post by **lidserter** » Wed Oct 16, 2019 6:25 pm

Hi! Did you executed "save all" command prior to power off the synth? If not, all recorded songs are lost.
If you save them, you should try to load the very last .SNG file. Doesn't matter if you clear all or append, the songs would load and you would be able to find them. On SEQ mode, the very first screen shows the song name, there you can select other song from the same sng file. Just to clarify, remember that each sng file may contain up to 128 songs.

Regards,
JJ

joedodd123 · Post by **joedodd123** » Sat Oct 19, 2019 9:18 pm

lidserter wrote:Hi! Did you executed "save all" command prior to power off the synth? If not, all recorded songs are lost.
If you save them, you should try to load the very last .SNG file. Doesn't matter if you clear all or append, the songs would load and you would be able to find them. On SEQ mode, the very first screen shows the song name, there you can select other song from the same sng file. Just to clarify, remember that each sng file may contain up to 128 songs.

Regards,
JJ

once iv appended or cleared, where do i go to find the song?

arpegiator1 · Post by **arpegiator1** » Fri Nov 01, 2019 10:19 pm

on the SD card where the .SNG file was saved. So if you have a card inserted into Microstation.

joedodd123 · Post by **joedodd123** » Fri Nov 08, 2019 5:56 pm

when i slelct clear or append it take me back to the provoius screen with noway of loading the song.. (korg kross 88 key)

joedodd123 · Post by **joedodd123** » Fri Nov 08, 2019 5:57 pm

arpegiator1 wrote:on the SD card where the .SNG file was saved. So if you have a card inserted into Microstation.

i found hte file but theres no way of playing it or loading it