Hello all,
I am trying to figure out a way to layer the same program or sound, but in octaves or fifths. Does this make sense? so the first sound would be say Grand Piano, then the second sound would also be Grand Piano, but at a 5th or an octave above whatever note is being played. Does anyone know how this can be accomplished? Thank you in advance!
layering octaves on programs
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
It is also possible to do this in Program mode where, just to be clear, Program mode is effectively nothing to do with computer programming, as such, but basically means single timbre mode, whereas a Combination is up to sixteen Programs or Timbres. Programs can consist of either one or two Oscillators, or sound sources, either of which can be transposed. Piano Programs tend to use sounds like the piano tailpiece for the second Oscillator, so don't lend themselves to doing the type of transposition you envisaged. Other Programs, e.g. synth type programs, might be better suited for using a transposition within a Program.
.
.
There will always be scope for learning, even after many years of using the Krome. The Operation Guide and Parameter Guide are extremely useful. If you are new to Korg keyboards, it will take a little while for the terminology to make sense. Like learning a new subject.
For Programs, the necessary settings are on edit page P2 OSC/Pitch, on the tabs: OSC1 Setup (and OSC2 Setup for a two oscillator Program). There, you will find four related settings, Octave (for whole octaves), Transpose (for semitones), Tune (for altering in Cents, i.e. one hundredths of a semitone), and a direct frequency offset, (in Hz). The latter could be used to generate a "beat" note between Osc 1 and Osc 2 that remains the same across the keyboard, though there are other ways to generate a rhythmicity within a Program e.g. using an LFO, or an arpeggiator.
.
For Programs, the necessary settings are on edit page P2 OSC/Pitch, on the tabs: OSC1 Setup (and OSC2 Setup for a two oscillator Program). There, you will find four related settings, Octave (for whole octaves), Transpose (for semitones), Tune (for altering in Cents, i.e. one hundredths of a semitone), and a direct frequency offset, (in Hz). The latter could be used to generate a "beat" note between Osc 1 and Osc 2 that remains the same across the keyboard, though there are other ways to generate a rhythmicity within a Program e.g. using an LFO, or an arpeggiator.
.
Every Combination that comes as standard, has the KROME Grand Piano allocated to the unused Timbres, so it is possible to unmute one of those, set it's MIDI channel to 01G and Transpose it and have fun experimenting. The changes you make are not stored or saved until you actually Write the Combi, using the top right drop down menu, so don't worry about messing up the keyboard sounds (in any case, they can be restored). As soon as you change to a different Combi, your changes are lost.
.
.