Hi !
After recording a drum pattern in the Electribe 2, can I somehow change the velocity value of certain steps of the sequence?
I want to give some dynamic to the drums by simulating harder or softres hits. I know I have some cool "groove" presets that I have already used, and also that I can activate velocity sensitivity, but sometimes the only way I can give the desired "feel" to the dequence is by editing some of the steps manually.
As I have never found how to do this, I always end up automating the part volume, but then I cannot change the part volume anymore...
How do you guys deal with this?
Thanks in advance!!
Electribe 2 can I change velocity value after recording?
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
I found it !!!
Just in case any other is interested in this:
1. Press "shift" + PAD 12 to enter "step edit" mode
2. Now you see the different STEPS of your sequence: select the step you want to modify
3. Now check the screen to see the available options: use the "arrow" button to navigate to the RIGHT until you find the "Velocity" page
4. Rotate the value knob to set the desired value
Enjoy!
Just in case any other is interested in this:
1. Press "shift" + PAD 12 to enter "step edit" mode
2. Now you see the different STEPS of your sequence: select the step you want to modify
3. Now check the screen to see the available options: use the "arrow" button to navigate to the RIGHT until you find the "Velocity" page
4. Rotate the value knob to set the desired value
Enjoy!