Korg MS 2000 dwgs waves issue

diegaso · Post by **diegaso** » Fri Jul 09, 2021 3:48 pm

Can someone please help me ?

I have a Korg MS2000R, and everything works fine, but it doesn't reproduce DWGS waves (none of the 64 included).

I have searched for comments on this matter, but there are none.

Regards

OpAmp · Post by **OpAmp** » Fri Jul 09, 2021 9:16 pm

Hi,

What exactly did you try?

After a factory reset, how does program A14 DWGS WaveSeq sounds like?

Bye

diegaso · Post by **diegaso** » Sat Jul 10, 2021 10:52 pm

OpAmp wrote:Hi,

What exactly did you try?

After a factory reset, how does program A14 DWGS WaveSeq sounds like?

Bye

Thank you very much for answering

I have reset the global factory settings, and the programs, and cannot reproduce any of the 64 voices included within the DWGS.

OpAmp · Post by **OpAmp** » Sun Jul 11, 2021 11:10 am

Hi,

I was asking how program A14 DWGS WaveSeq sounds like after a factory reset, because it uses the DWGS waves by default.

If you did factory reset of the programs and it still does not work, then your unit is likely broken somehow... Too bad

Bye

diegaso · Post by **diegaso** » Sun Jul 11, 2021 4:09 pm

Okay, I'll have to take it to a technical service.

Thank you very much.

OpAmp · Post by **OpAmp** » Sun Jul 11, 2021 7:23 pm

Good luck, because this board is already quite dated.
Keep us posted on whether this could be fixed in the end.