Why is the Vocoder Refusing to Behave in SEQ Mode

[icecoldrocker]

As you can see I have been using Korg for a very long time

However the night before typing this I spent a massive amount of time chasing the vocoder set up in SEQ MODE at least four hours trying to get it to work.

So here it goes...

1. Copy from Program O-126 Vocoder Mic Input -1
2. I swear I kept setting the FX Control to 1
3. Set to FX Control 1 in Audio Track Tab
4. Set to Rec Bus on Audio Tab to 1
5. test mic while playing a chord
6. I get the sound from the chord but the voice is not going thru the effect

I went back and forth with this for about up to a total of four hours with even referring to the manual but the audio signal would not route through as hoped until I chose from IN-Track Sampling for which I do not wish to do. However when I did choose this selection the signals now [seemed] to route as ex-pected.


so would this not work the same as in SEQ Mode ?
Unless we have changed something then just copying from Program and selecting how the Effect Setup / Routing would copy in-to the SEQ Insert effect section ?
2. For the Audio Input, set the FX Control Bus (0–8c) to FX Control 1.
This sends the audio input to FX Control Bus 1.
3. In IFX1: Vocoder, set the Modulator Source to FX Control 1.

[Dan Stesco]

Maybe is about the audio settings from Audio input. Check in SEQ if is set Use Global Settings. I think in vocoder programs is not select as Global settings but I can't check myself today. So even you copy from program the audio input settings is same as Global that mean audio input is not Bus to Ifx 1 as in Vocoder Program.
Go to SEQ Audio In Sampling, Unselect the Use Global Settings, set the Audio Input 1 Fx Ctrl BUS to IFX 1.

[icecoldrocker]

I did not have this run around while on the M3 with the Vocoder ok so ya got the Vocoder set up correct then you record on a track because you need the track where the Vocoder is coming through to trigger with the voice SINCE YOU DONT WANT TO PLAY THE while the song is playing. and also while using this vocoder when i’m switching from record modes there’s a loud high pitch sound that i know if i don’t watch out this can damage the headphones good thing i’m not using studio monitors one would be blown out by now.