Loading PCG from FDD

[Classic49]

Hi.
I may be missing a step but I am trying to load programs from a pcg file but am not seeing them in the bank.

I have the EXBPCM08 card installed and am trying to load programs/combinations using the floppy disk (created from download from KORG website). I choose D_BANK.PCG, click Open, then with Programs selected, click Open again. “Bank D” is displayed which again I click Open and see a list of programs.

If I then go to Prog and Bank D I still see the internal programs (000: Ribbon Morpher”.

Any advice would be appreciated.

[voip]

Are the relevant Memory Protect checkboxes enabled in Global mode? They should be disabled.

Could the floppy drive be having issues reading from the disk?

.

[Classic49]

Thanks for your reply. None of the memory protect checkboxes are ticked and the FDD seems to be reading ok.

[bpoodoo]

Hi.
I may be missing a step but I am trying to load programs from a pcg file but am not seeing them in the bank.

I have the EXBPCM08 card installed and am trying to load programs/combinations using the floppy disk (created from download from KORG website). I choose D_BANK.PCG, click Open, then with Programs selected, click Open again. “Bank D” is displayed which again I click Open and see a list of programs.

If I then go to Prog and Bank D I still see the internal programs (000: Ribbon Morpher”.

Any advice would be appreciated.

Did you actually "Load" the programs? "Open" is like browsing the directory structure. You must then "Load" what you have selected - in this case either the entire Bank D or individual programs listed within Bank D. Note: You can also preview (manually audition) each program in the floppy list by selecting it.

[Classic49]

Hi.
I may be missing a step but I am trying to load programs from a pcg file but am not seeing them in the bank.

I have the EXBPCM08 card installed and am trying to load programs/combinations using the floppy disk (created from download from KORG website). I choose D_BANK.PCG, click Open, then with Programs selected, click Open again. “Bank D” is displayed which again I click Open and see a list of programs.

If I then go to Prog and Bank D I still see the internal programs (000: Ribbon Morpher”.

Any advice would be appreciated.

Did you actually "Load" the programs? "Open" is like browsing the directory structure. You must then "Load" what you have selected - in this case either the entire Bank D or individual programs listed within Bank D. Note: You can also preview (manually audition) each program in the floppy list by selecting it.

Thank you so much. I had missed the "Load" button at the top of the screen and thought that "Open" was the only option.