Synchronizing Radias.

tablet · Post by **tablet** » Thu Jan 10, 2008 10:02 am

I have the esx1 the Radias connected with Esx1 and Qusimidi 309.I have set Esx as master then 309 as 1st slave and Radias as 2nd slave.When I hit play on Esx the Quasimidi starts playing but the Radias is not.I have to hit lauch and then a note to start playing and when I'm doing that is not synchronizing with the others.Does anyone has the same problem?Am i doing something wrong?I have spent to many hours to figure it out but i haven't yet..Please help!!!! Thanks a lot!!

meatballfulton · Post by **meatballfulton** » Thu Jan 10, 2008 1:03 pm

tablet wrote:I have to hit latch and then a note to start playing and when I'm doing that is not synchronizing with the others.

The Radias sequencers are not song sequencers. They require you to play a note to start them, they do not respond to song start/continue/stop commands.

The arpeggiator works the same way.

tablet · Post by **tablet** » Thu Jan 10, 2008 5:06 pm

Once i had connected with Esx and while i was changing some parameters (I don't remember which one,that's the problem) when i was hitting play on Esx Radias was started.I'm wondering what's happening...

meatballfulton · Post by **meatballfulton** » Thu Jan 10, 2008 7:13 pm

Actually I stand corrected. From page 150 of the manual:

If the RADIAS’ arpeggiator is synchronized to a connected
external MIDI device, you can use Start/Stop
system realtime messages to control the arpeggiator and
step sequencers.

Start [FA]
When a Start message [FA] is received, the arpeggiator
will start from the first note that is played. The step sequencers
will start from step 1.
If the “Key Sync” of the modulation sequencer or LFO is
turned off, the phase will be reset.

Stop [FC]
When a Stop message [FC] is received, the arpeggiator
and step sequencers will stop. Since this is not an “off”
message, the arpeggiator will start again when it is triggered.

So if your patch has one or both step sequencers enabled, they should start up with the ESX.

The arpeggiator will only start after you play a note.

tablet · Post by **tablet** » Thu Jan 10, 2008 11:46 pm

So i have to make the correct right settings from the Esx right?Thanks very much for your time and help!!!

tablet · Post by **tablet** » Fri Jan 11, 2008 9:05 am

Thanks a lot!I found it.I had to send the sequencer from radias to midi ch 10 at the Esx...

Korg Forums

Synchronizing Radias.

Synchronizing Radias.

Re: Synchronizing Radias.