Individual 1/2 outputs and running stereo to a PA

Fatalmasterpiece · Post by **Fatalmasterpiece** » Mon Feb 18, 2008 10:12 pm

On the TR61...

Is there any way to route sound through these output jacks in addition to the stereo jacks?

I ask because I would like to send a stereo signal to the PA and also send a signal out to a combo amp near me to use as a monitor.

As far as I can tell the manuel tells me that I can only route drums or a single timber through them.

I am going to try running the stereo outs to a PA and perhaps use the headphone jack to run to my combo amp monitor however I am not sure if it will mute the stereo channels when I do that.

Voltan · Post by **Voltan** » Mon Feb 18, 2008 10:18 pm

you can run anything you want throught main out OR individual outputs but not through both simultaneously

the headphone stereo jack mirrors the Main L/R pair, it won't mute the main out, I actually did use it for monitoring with my Triton LE

Fatalmasterpiece · Post by **Fatalmasterpiece** » Tue Feb 19, 2008 12:48 am

Sweet, thanks Voltan. I think I will run the comboamp out of the headphones jack and run stereo to the PA through the back. I just didn't want to run mono to the PA and have my keyboard sounds worse than it should.

Voltan · Post by **Voltan** » Tue Feb 19, 2008 1:04 am

the only problem is that it's a stereo jack so if you're gonna run it through a mono amp, you'll probably hear only one of the channels
not a big deal unless you use a lot of panning in your combis, I guess

Fatalmasterpiece · Post by **Fatalmasterpiece** » Tue Feb 19, 2008 6:27 pm

nope, I dont use much panning.

I DID want to run the stereo outs to a stereo pa however because it sounds fuller.

The headphones jack will be running to a mono amp like you said but its just for me to hear myself or to add alittle more sound.