how to connect an electribe and microkorg.

trypset · Post by **trypset** » Mon Feb 25, 2008 12:18 am

Ok so I have a ES1-MKII electribe sampler, and a microkorg. What would be the most efficient way to use the MIDI. Should I have the electibe setup as the slave, running into the microKorg. Or vise versa? How can i make beats and also run synth patterns at the same time? How is everyone else using the two together?

powers · Post by **powers** » Mon Feb 25, 2008 10:51 am

You basically want to pull off what Enter Shikari and countless other people do with EMX-1's.
You should be able to slave one to the other with a midi cable, and then the midi clocks will sync.
I suggest you check out this post this post

This guy is doing it with 2 electribes, but the concept is still the same.
Another Example

Also, I believe this has been answered here

powers · Post by **powers** » Mon Feb 25, 2008 11:27 pm

Also:
http://www.korgforums.com/forum/phpBB2/ ... hp?t=31487