start playing sample on pattern start

defex · Post by **defex** » Sun Jun 01, 2008 2:48 am

Greetings kaossians! i have joined this forum to ask a question about the kp3. (its been updated to v 2.0)

Is there any way to make the samples always play synced to MIDI? Its fine when im creating the samples and everything is running, but once i stop the MIDI clock and start it again you have to hit the sample buttons dead on to get the sample to play right.

sometimes i would like to hit play for a short time and hear the middle of a sample which is internally playing as a loop which was started on the "start" command in the MIDI clock.

thanks
DeFex

decrepitude · Post by **decrepitude** » Mon Jun 02, 2008 12:54 pm

Covered in the tips and tricks thread.

m4m · Post by **m4m** » Thu Jun 05, 2008 11:15 pm

yes and no
you have to do t manually as the 2 most important remote functions (beat reset and sampling) have NO MIDI WHATSOEVER, still hoping for 2.1 to address that

but the shift tap will do the trick (and mess any sample that you DIDN'T record starting on the 1 of the others