PADKONTROL Help

ltrain400 · Post by **ltrain400** » Thu Jul 24, 2008 12:57 pm

I am having trouble getting this Padkontrol too work... I have installed about thirty drivers..... it says that it is working fine, i can transmit/receive through the editor but i am getting no noise... reason is even detecting it but i still cant get it too work...

Post by **mikemolloyuk** » Thu Jul 24, 2008 1:17 pm

Hi

If your getting the editor to communicate with it then it is working ok. You need to check your midi settings in Reason to make sure that it is pointing to the PK.

If you are on a Windows PC try installing midiox

www.midiox.com

This will allow you to see that the PK is broadcasting midi messages.

Please remember that the pad does not have sounds of it's own it has to control something else. There seems to be a slight missunderstanding with some users about our control products not playing anything internal.

ltrain400 · Post by **ltrain400** » Thu Jul 24, 2008 5:27 pm

hey i appreciate the reply.....

I fully understand that this is a MIDI controller and that it does not have its own sounds.. I will try and install this and see if it helps!!!

Does anyone know if you can play tones out of the editor library!!!! i am not getting a sound out of it, and it seems since you can change notes, curves, etc..... you would be able to hear them

THANKS AGAIN

Post by **mikemolloyuk** » Fri Jul 25, 2008 8:15 am

Hi

No the editor wont play tones, it's merely for the settings that the PK uses.

Mike