EG3?

Dionysos2 · Post by **Dionysos2** » Sun Sep 28, 2008 3:35 pm

I'm not really aware of the EG3?
Where can I find the EG3 or control it?
I really have no idea.

rfoshaug · Post by **rfoshaug** » Sun Sep 28, 2008 4:21 pm

If we're talking about the Radias here, you must press Edit/Yes to enter edit mode, then press the EG button (button number 9 from the left). Press it several times while watching the screen to choose between EG1, EG2, and EG3. Then set the parameters of EG3 on the screen using the cursor keys and dial.

Then you can use virtual patches to make EG3 control one or several synth parameters.

Dionysos2 · Post by **Dionysos2** » Sun Sep 28, 2008 4:33 pm

oh yeah its the radias.
Thank you very much!
So the EG3 isn't really editable by any knobs?

Thanks for the fast reply

meatballfulton · Post by **meatballfulton** » Mon Sep 29, 2008 4:58 am

EG3 is in the menus only, no more room for knobs on the front!

Timo · Post by **Timo** » Mon Sep 29, 2008 5:29 pm

Most synths have one or two EGs (usually assigned to the Amp and the Filter respectively) and one or two LFOs on the fascia, with others behind menus.

Press the "Edit/Yes" button, then on the far left of the Radias make sure "Page" is selected, then press button number "9" from along the bottom. This will take you to the EG menus where you can fine-tune settings for all EGs (1, 2 and 3).

For modulation purposes, you can find/control EG3 (and 2 and 1) as a source from within your Virtual Patch matrix.

rfoshaug · Post by **rfoshaug** » Tue Sep 30, 2008 7:55 am

Thank you, Timo, for repeating exactly what I said 3 posts up.

Timo · Post by **Timo** » Tue Sep 30, 2008 2:23 pm

rfoshaug wrote:Thank you, Timo, for repeating exactly what I said 3 posts up.

My bad. Posted without reading.

rfoshaug · Post by **rfoshaug** » Wed Oct 01, 2008 8:03 am

No problem at all, mate.