Hey there.
I just got my pad kontrol and I'm using it with FXpansions Guru and OSX 10.5.6
i have just found out about farmpad and installed it. When I go into terminal and start farmpad, nothing happens on the kontrol. No LED's flash on the kontrol or anything.
In terminal this pops up
"ash-sagars-macbook-pro-15:~ ashsagar$ farmpad
farmpad v1.3.1
------------
Connected to padKontrol.
Entering active mode."
i'm a total noob with terminal so I may be missing some big thing.
Any help would be appreciated. thanks
Ash
Farmpad
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Hi Ya,
Sorry for the lack of reply, i honestly don't know what's wrong....
Are you running the bog standard farmpad before making any config file? if so then i haven't a clue.... if you are using a config file then do a search on farmpad on here as i can't remember the exact answer but it's been covered a couple of times.... alternatively post in the farmpad thread as Farmpads creator often comes back to post....
Cheers
D
Sorry for the lack of reply, i honestly don't know what's wrong....
Are you running the bog standard farmpad before making any config file? if so then i haven't a clue.... if you are using a config file then do a search on farmpad on here as i can't remember the exact answer but it's been covered a couple of times.... alternatively post in the farmpad thread as Farmpads creator often comes back to post....
Cheers
D
Hey S4racen. Thanks for the reply.
I have started from the bogstandard farmpad in terminal. I've started by dragging a config file. Nothing works.
Farmpad does recognise my PK cos when I boot farmad without it attached I get an error
ash-sagars-macbook-pro-15:~ ashsagar$ farmpad
farmpad v1.3.1
------------
Error connecting to padKontrol input.
ash-sagars-macbook-pro-15:~ ashsagar$
So something must be happening but what, I'm not too sure.
I did post on the farmpad thread as well as PMing flycycle but since it's xmas and all that jazz I guess he/she's taking a little time out.
Anyway, again, thanks for the reply, I was getting cabin fever over here all alone like that
Cheers
Ash
I have started from the bogstandard farmpad in terminal. I've started by dragging a config file. Nothing works.
Farmpad does recognise my PK cos when I boot farmad without it attached I get an error
ash-sagars-macbook-pro-15:~ ashsagar$ farmpad
farmpad v1.3.1
------------
Error connecting to padKontrol input.
ash-sagars-macbook-pro-15:~ ashsagar$
So something must be happening but what, I'm not too sure.
I did post on the farmpad thread as well as PMing flycycle but since it's xmas and all that jazz I guess he/she's taking a little time out.
Anyway, again, thanks for the reply, I was getting cabin fever over here all alone like that
Cheers
Ash