i want to set something with farmpad who can help me?

Discussion relating to Korg Controller products.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
logritm
Posts: 5
Joined: Tue Feb 03, 2009 9:29 pm
Contact:

i want to set something with farmpad who can help me?

Post by logritm »

hi, i'm sorry for my bad english...

i've tried to setup my padkontrol with farmpad...to use it with ableton live...

it's super i never have see something like this......my setup show me only the clips that i play in that moment....and i have 128 scene x 16 pad and i can start every clip in my liveset....
my first scene is like a drum rack....and with the others start the clip...

the other buttons are used to effects on and when i change my scenes the same buttons don't change the midi signal( becuse i have decided that they must have the same channel) so i can use these button effects in every scene for the same efx......

my problem his.......... in my scene my effect is on and the light is on......
when i change program in the next scene my effect is on but the light turn off.....

what is the code that i must use.....

i've tried everything i know.......somebody can help me?
when my project will be finish ....i want to share with web because its too fun....
thanks
S4racen
Junior Member
Posts: 67
Joined: Wed Jan 23, 2008 11:14 am

Post by S4racen »

Hi ya......

Could you post your config file up? I'm not sure what your attempting, as youy change scenes the lighted pads reflect the state of the pad the last time you were in the scene..... If all the scenes are set to transmit the same midi messages then it won't be as intuitive as you want it to be....
0
Have you considered looking into the automap function of Live? By using farmpad to broadcast certain messages on certain channels you can control whichever rack is in focus at that time......

Cheers
D
logritm
Posts: 5
Joined: Tue Feb 03, 2009 9:29 pm
Contact:

Post by logritm »

this is my configuration:::

[EncoderSelectsScene]


//Set Scene 16 for Drum Rack AutoMap
scene:1
pad:all
channel:1
control:off
led:d R
velocity:soft
mode:trigger

pad:1
note:61
pad:2
note:69
pad:3
note:65
pad:4
note:63
pad:5
note:60
pad:6
note:59
pad:7
note:57
pad:8
note:55
pad:9
note:49
pad:10
note:51
pad:11
note:68
pad:12
note:56
pad:13
note:48
pad:14
note:52
pad:15
note:54
pad:16
note:58



// x dare lo stesso midi learn a tutti i tasti tranne i pad
scene:2-128

switch:1-19
channel:2
knob_1:92
channel:2

knob_2:93
channel:2
xypad_x:90
channel:2

xypad_y:91
channel:2







// pad groups
scene:2-128

velocity:hard
pad:1-4
group:1

// assign pads 5 to 8 to group 2
pad:5-8
group:2

// assign pads 9 to 12 to group 3
pad:9-12
group:3

// assign pads 13 to 16 to group 4
pad:13-16
group:4



now it's ok.......i have write channel 2 to the switch buttom
Post Reply

Return to “Korg Kontrol49, microKontrol, padKontrol, nano and K series controllers”