Krog Zero 4 windows service pack 2 and traktor

[shawn benjamin]

Hello,


My computer just downloaded a new update (service pack 2) for Windows Vista.

And traktor went from smooth to bumpy (not in a good way clicks pops ect.)



1) I turned on the laptop and ran DPC latency checker. I see all my green bars hugging the floor. With the odd short yellow bar.

2) I turned on my korg zero 4 and run DPC again. (note - I have not started traktor yet) This is where my problem is beginning now I'm getting 4 or five yellow bars in a row and then a green bar or two followed by more yellow. This was not the case pre vista service pack 2 I was seeing mostly all green.

3) I start traktor and run DPC again and get the same result 4 or 5 yellow bars in a row and then a green bar.

I will dig a little deeper into the windows services with my zero 4 on and see what I can find.

If I don't have nay luck I will try uninstalling service pack 2 (I'm not hopefull about this as windows never really uninstalls anything that well.


anyone else have this problem?


If anyone has other suggestions let me know.

best

shawn

[driverdj2000]

i know an upgrade to service pack 2 in xp caused a major loss in firewire quality.
there was a fix for this from microsoft. perhaps the same thing has happened with vista.
try searching microsofts site for info.