Hey guys,
So I was using Traktor Scratch Pro with my Zero4 and external control, and it seemed to work fine. Then I jumped over to mess around with internal mixing for a while, and left TCV by the wayside. I tried to get external vinyl control going today and... nothing. The external control doesn't work and I have no idea why. The scratch panels don't move, and the track doesn't play when the vinyl does. Internal mode still works fine.
I tried reinstalling the 1.6 Zero4 firmware. No dice. I'm using the Traktor Adapter program, set correctly. No dice.
I used to be able to use my Zero4 with Torq as well, and that doesn't work either.
When I use my Audio 8 DJ I can use timecode control, no problem.
It's very weird. I'm on OS X 10.4.11, Traktor Scratch Pro 1.1.2, Zero4 (with 1.6 firmware).
Any help would be great. Thanks.
Problems with Traktor Scratch Pro, Zero4, and xtrnl control
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Hey for anyone else having this problem, you can do a reset of the mixer, and it resolves it.
1. Turn the mixer off.
2. Press and hold Gate Play and Cue Split.
3. Turn the mixer on.
4. The little LCD screen should say "init"
Then you should be good to go! It doesn't reset your firmware, which is a good thing actually.
I think this happened because my SCS.3D's TSI file hates my Zero4 and there was some kind of conflict. The SCS.3D wants to control the decks and not accept time code, and you need to tell it to f*ck off via resetting the mixer.
1. Turn the mixer off.
2. Press and hold Gate Play and Cue Split.
3. Turn the mixer on.
4. The little LCD screen should say "init"
Then you should be good to go! It doesn't reset your firmware, which is a good thing actually.
I think this happened because my SCS.3D's TSI file hates my Zero4 and there was some kind of conflict. The SCS.3D wants to control the decks and not accept time code, and you need to tell it to f*ck off via resetting the mixer.