KORG EXP-2 Foot Controller HELP!

wolferl3.1 · Post by **wolferl3.1** » Thu Nov 26, 2009 3:04 am

Can anyone help me with this thing.

I don't know where to plug the jack with it's 2 outputs and 1 input. And what is the 0-10 slider for?

I tried setting my global Foot Pedal assign to Foot Pedal CC#04, saved it and when i tried using it on any programs that has wah, it doesn't respond. I already changed the d-mod source to Foot Pedal CC#04, wah is on, sweep range is -10 and it still doesn't work.

I already tried putting the jack on either of the 3 holes in my pedal but still can't control any effects.

Synastikki · Post by **Synastikki** » Thu Nov 26, 2009 12:26 pm

I'm not sure because I don't have the pedal, but I would set it up from output 1 to assignable pedal jack in the triton and for the slider it is the minimum setting so if you want to use the full range put it to 0... The thing why your pedal might not be working is that you need a STEREO CABLE... while normal cable has one ring, Stereo has two rings... http://cachepe.zzounds.com/media/qualit ... 590732.jpg

wolferl3.1 · Post by **wolferl3.1** » Fri Nov 27, 2009 5:02 am

they say you use it with a 3 conductor cable?

i'm using the cable that i normally use for the L/Mono or stereo.

where should i put the output on 1 or on 2? cause it says 2 - output -1.

McHale · Post by **McHale** » Fri Nov 27, 2009 5:37 am

top = bad

bottom = good.

Synastikki is correct. It has to be a stereo 1/4" cable.

-Mc

Synastikki · Post by **Synastikki** » Fri Nov 27, 2009 12:30 pm

I believe that both 1 and 2 work, but with common sense I would try the output 1 first

McHale · Post by **McHale** » Fri Nov 27, 2009 3:34 pm

The only expression pedals I have are the Yamaha FC-7 but those are stereo plugs. Wouldn't the manual say?

-Mc