transfering sounds from a micro korg

benfiltraitor · Post by **benfiltraitor** » Wed Apr 07, 2010 1:55 am

is there any way i can put the rad sounds of a micro korg onto the korg M3?

sipa · Post by **sipa** » Wed Apr 07, 2010 2:28 am

You can make patches to m3 by hand? You just open up the patches you have on microkorg to editor, and mimic the settings to m3 editor, then upload patches to m3 and ur done.

Cheers
- sipa

benfiltraitor · Post by **benfiltraitor** » Wed Apr 07, 2010 3:56 am

hey thanks for that,

but i dont really understand what your trying to say

X-Trade · Post by **X-Trade** » Wed Apr 07, 2010 11:17 am

I don't really think anyone else understands what you are trying to say either.

Can you just load MicroKorg sounds into the M3? No.
What you can do is program the patches yourself by using the M3 screen or editor to copy or at least make a close approximation of the patches, probably using the EXB-Radias.

You can download the MicroKorg editor (or the Radias, R3, MicroKorg XL editors) without actually owning the device. You can still load libraries and look at the parameters.

From there you can go from screen to M3 copying the parameter value for each program you want on your M3.

I think you were asking if you could load the Radias converted MK/MS2000 patches for the EXB-Radias? The answer is no, they have a different file format and some differences between the EXB and the actual Radias module. Again, you would probably be successful by copying the parameters using the technique above.

In fact you'd be better copying from the R3 editor because they have the same DWGS section as the EXB, whereas the Radias has some choir, string, EP, etc PCM samples.