pattern sequencer default setting

bitfader · Post by **bitfader** » Thu May 26, 2011 6:41 pm

Wondering if there's any way to get the microsampler pattern sequencer to always chose my user defined settings of 8 measures, quantize 16 instead of the default 4 measure quantize off....it's a real pain setting this up every time.

Re-Member · Post by **Re-Member** » Fri May 27, 2011 9:41 am

You could just dial in those changes, save it to the last bank, then anytime you begin work start at that last bank and remember to save to different one. You could also use the PC editor to save a default set up for you to load up anytime. I did this since I got sick of dialing in very specific reverb settings I use on every bank with drums samples.

bitfader · Post by **bitfader** » Fri May 27, 2011 4:43 pm

the software won't let me specify quantize settings only bar length, but the template pattern block you suggest might be a alternate workaround.
I wish the software gave total control.

Re-Member · Post by **Re-Member** » Sat May 28, 2011 3:03 am

Didn't realize that the editor doesn't let you tweak sequencer data. I actually haven't even attempted to record sequences or samples on the machine itself, seems all a bit complicated, haha. I cheat and just use the editor to load samples and a MIDI file.

wojtysz · Post by **wojtysz** » Fri Jun 10, 2011 6:23 pm

Good to know that it saves a pattern length through bank setting save. I now noticed that it remembers all the settings of each pattern when recorded and saved. I think it works as "remember last setting" which is good.